Zephyr 1100 A2 head bearings
Zephyr 1100 A2 head bearings
piecing together the head bearings on my 1100 A2 which has been apart for 'a while' . I have the new bearings and seals but he bottom yoke has a machined collar which is preventing the bearing seal and race seating right down on the yoke properly. does anything else go here or is there supposed to be a gap (and have I got the seal the right way up ?), cheers
1995 ZR1100A2
Re: Zephyr 1100 A2 head bearings
no there shouldn't be a gap - but your Yoke is ok, looks like every other one from a 1100!
as is see you use ab aftermarket seal with a thin Steel plate on the bottom. the inner Diameter of this seal is to small so it won't fit the collar of the Yoke.
the OEM part has a bitter inner diameter and is thicker so ist compensates the collar and gives a flat level for the Bearing. the Bearing has to sit on the collar.
get the original Seal an your Problem is gone
Greetings from bavaria
as is see you use ab aftermarket seal with a thin Steel plate on the bottom. the inner Diameter of this seal is to small so it won't fit the collar of the Yoke.
the OEM part has a bitter inner diameter and is thicker so ist compensates the collar and gives a flat level for the Bearing. the Bearing has to sit on the collar.
get the original Seal an your Problem is gone
Greetings from bavaria
Re: Zephyr 1100 A2 head bearings
I Dremel'd the metal inner plate of the seal to fit the collar on the bottom yoke to suit and all back together now , cheers .
1995 ZR1100A2