Oil pressure switch sealing?
Oil pressure switch sealing?
Hi, I’m doing a remove the oil pan and check the strainer oil change ( all clear by the way) . The Removed oil pressure switch has no oil seal but the remains of some compound. Is there a recommended thread seal or will tread tape be adequate?
Re: Oil pressure switch sealing?
Not doing the strainer job again. Struggling getting the pan back on. Rubber hose and plastic oil filter causing grief. Leave it and have a go tomorrow.
Re: Oil pressure switch sealing?
Should just read the manual It recommends silicon sealant. Pan on, used a bit of silicon grease to keep the oil breather tube in place.
Just waiting for the various banjo gaskets from MSP in the Netherlands https://www.motorcyclespareparts.eu/en , Could not find them at Wemoto. Big job just to check the strainer .
Just waiting for the various banjo gaskets from MSP in the Netherlands https://www.motorcyclespareparts.eu/en , Could not find them at Wemoto. Big job just to check the strainer .
Re: Oil pressure switch sealing?
Hi Herron sorry just seen this post, re the oil pressure switch , thread tape will be fine for that job. I've always used it for that sort of thing at work , oil drain plus etc. PTFE thread tape is good for 150 deg C and about 20bar
1995 ZR1100A2